Hey， Ladies and gentlemen, today let's talk about a super practical building material - punched aluminum veneer. This thing is becoming increasingly popular in modern architectural decoration, not only for its beauty and elegance, but also for its various creative effects. Imagine sunlight shining through carefully designed holes indoors, the feeling couldn't be better!

We need to talk about the installation method of punched aluminum plates. This matter is actually not that complicated, mainly consisting of the following steps:

1. Base treatment: Ensure that the base of the wall or ceiling is flat, clean, and free of oil stains.

2. Positioning and laying out: Determine the installation position of the aluminum veneer according to the design drawings and mark it with wires.

3. Fixing the keel: Fix the keel according to the marked position, paying attention to the even spacing between the keels.

4. Installation of aluminum veneer: Hang the punched aluminum veneer and adjust its position to ensure a tight fit with the keel.

Installation method of punched aluminum plate

When installing punched aluminum veneer, there are several precautions to be aware of:

1. The fixation of the keel should be firm: otherwise, the aluminum veneer is prone to falling off, causing safety hazards.

2. The hole position should be accurate: ensure that the hole position is consistent with the design drawing to avoid deviation.

3. The installation sequence should be reasonable: install from top to bottom or from left to right to avoid collision damage.

What are the precautions for installing punched aluminum veneer

Let's discuss the aperture and punching rate of punched aluminum veneer. The aperture and punching rate are key factors in the design of punched aluminum veneer, directly affecting its aesthetics and practicality.

What is the aperture of perforated aluminum plate? How to calculate the punching rate of perforated aluminum veneer

The aperture range of punched aluminum veneer is between 1-10mm, and the specific size should be determined according to the design requirements. The punching rate is the ratio of the total area of holes to the total area of aluminum veneer, usually between 2% and 20%. The selection of aperture and punching rate should take into account factors such as load-bearing capacity, aesthetics, and ventilation of aluminum veneer.

Let's talk about the difference between punched aluminum veneer and honeycomb aluminum sheet again. Although they are all aluminum sheets, their materials and properties are still different.

What is the difference between perforated aluminum veneer and honeycomb aluminum sheet? Can aluminum honeycomb sheet be punched

Punched aluminum veneer is made of pure aluminum or aluminum alloy, with high strength and corrosion resistance. And honeycomb aluminum plate is formed by pasting honeycomb paper on both sides of the aluminum plate to form a honeycomb structure, which has superior sound insulation and heat insulation performance. As for whether aluminum honeycomb panels can be punched, the answer is yes, but the aperture and punching rate need to be designed according to the thickness and strength of the honeycomb paper.

Punched aluminum veneer, as a new type of building material, has a wide range of application prospects. Hey guys, do you have any creative ideas to use punched aluminum veneer to achieve it? Come to the comment section and tell me! 👇👇👇